Ethernet communication module is usually used as the communication interface of PLC. It is based on the traditional Ethernet communication mechanism and uses Ethernet and TCP/IP protocols as the commu..
In the PLC file, the register addresses range from D1000 to D2999, covering a total of 2000 data points. These data points are associated with input and output signal codes and address numbers in the ..
BCNet-S7 Ethernet communication Module is used for Siemens S7200/300/400 series PLC control system and Siemens 840D, 840D SL CNC system.Replacement for CP343 and CP3411. Open STEP7 software, create a ..
BCNet-FX is a Mitsubishi Ethernet communication module that supports the Mitsubishi programming software GX Works2 for program download and monitoring FX series PLCs.There are three ways to set up the..
Siemens Simatic S7-200 Ethernet ConnectionA communication scenario is shown in this diagram:There are two ways to program and debug MicroWIN with BCNet-S7 modules: via the BCNet programming driver or ..
BCNet SoftwareBCDevice_V1032 Applicable to BCNet-S7200/300/FX/Q/CP/CJ/FP/DVP/XJ/KV seriesBCNetModbusTCP C# example (Modbus TCP)modscan2.rarmodscan can be used for Modbus TCP and Modbus RTU communicati..
Ethernet/IP is a specific industrial Ethernet protocol commonly used in automation and control systems for real-time data exchange and communication between devices.If the PLC with Ethernet port, it s..