This is 3/4/5 Axis DSP manual CNC controller. It can read and run G-CODE from U-disk. You could operate without computer.
This controller can be applied to engraving machine, CNC machine and automatic production line.
manual from www.nvcnc.net
Read G-CODE from U-DISK;
Operation without computer;
8 ports photoelectric isolated input interface;
5 ports photoelectric isolated output interface
1 port 0-10V spindle speed analog output interface (can change to PWM output);
Can support 3/4/5 axis stepper systems, 125 KHz pulse output for every axis;
ARM motion control chip;
Main device is 24VDC power supply input; current should higher than 1A;
Support standard MPG and NVMPG;
3.5'' TFT screen;
19 user key
Appearance and size
The Hand control system NCH02 appearance as the Figure 1-1 show: The host system NCD02 appearance as the Figure1-2.
The Hand control system NCH02 overall size is 168mm*108mm*30mm；
The host system NCD02 overall size is 100mm*70mm*23.5mm
When operate the NCH02, where will be a lot of English abbreviation, now we list all of them for your kindly references:
FRO: Feeding adjusts: During the operating process, the F value already set, and need to adjust the current feeding speed, then we can adjust FRO value to realize it.
SRO: Spindle speed adjust: During the operating process, the S value already set, and need to adjust the current spindle speed, and then we can adjust SRO value to realize it:
Current Speed S#=setting S*SRO.
SRJ: speed adjust manually
During the operating process, as the manual speed already set, and we need to adjust the current speed, and impossible to fix the value during it is working, then we can revise the SRJ value to realize it.
Current manual speed FS#=Setting manual speed*SRJ.
F: Feedingspeed, the unit is mm/min. For example F=200, means every minute feeding
S: Spindle Speed. Unit is rad/min. For example S=20000, means 20000 revolution/Minute.
X axis Coordinate
Y axis Coordinate
Z axis Coordinate
A axis Coord
B axis Coordinate
C axis Coordinate
Ready: ReadyMode. In the mode we can do any operation, include processing or values modification or starting 2nd mode.
Reset: Reset mode. In this mode, it should stop every operation.
“Step”: Manual Step Mode. Every axis can conduct the manual step operation at this mode.
MPG: MPG mode. Every axis can conduct the MPG operation at this mode.